Architect's & Engineer's Specifications

The powered loudspeaker system shall have a frequency response from 65 Hz to 20 kHz. The peak SPL with inaudible distortion shall reach 123 dB with music as a source, when measured at a distance of 1 meter and driven to full output capacity. The system shall utilize a Peavey Pro 10 10 inch heavy-duty woofer and a Peavey RX 10 1 inch titanium diaphragm dynamic compression driver. The nominal radiation pattern shall be 100 degree in the horizontal plane, and 60 degree in the vertical plane. Axis of the vertical main polar lobe is angled down 10 degrees, resulting in the angular pattern with respect to straight ahead being +20, -40 degrees. The powered, bi-amplified loudspeaker system shall have three input channels consisting of a medium impedance input connector consisting of one combo female XLR and 1/4 inch TRS phone jack for channel 1 and channel 2 on the rear panel. Channel three shall provide Bluetooth signal source input control, as well as doubling as an AUX in for a 1/8 inch phone jack. There shall be a output connector consisting of a male XLR jack. The system power amplifiers shall have an unfiltered frequency response of 20 Hz to 20 kHz which deviates no more than +0, -3 dB up to rated power, hum and noise better than 90 dB below rated power, and THD and IMD of less than 0.5%. The woofer amplifier shall be capable of 160 Watts sine wave power output into a 4 Ohms nominal load, and the tweeter amplifier shall be capable of 45 Watts sine wave power output into a nominal 8 Ohms load (with compression and limiting bypassed), and both shall incorporate independent DSP controlled signal compression. The input signal shall be electronically divided into high frequencies and low frequencies by a fourth order slope line-level crossover at 1.8 kHz. The low frequencies shall be processed to provide bass boost, subsonic filtering and overall response shaping, and the high frequencies shall be equalized for response-shaping. The enclosure shall be constructed of injection-molded plastic with a UL flame rating, and reinforcing ribs internally. A handgrip shall be incorporated on the right side near the woofer and towards the front of the cabinet. A separate powder-coated metal grille shall be provided for horn and woofer protection. The cabinet shall incorporate a pole mount for speaker stand use, four tall sturdy rubber feet for floor standing use, and two sets of mounting point
inserts on the top and bottom each, for flying use. The outside dimensions shall be: 20 inches (508 mm) tall x 12.69 inches (322 mm) wide x 11.06 inches (281 cm) deep, and the weight shall be 27 lbs (12.4 kg). Power requirements shall be: 100 Watts nominal, 100-120 VAC, 50/60 Hz Domestic and 220-240 VAC, 50/60 Hz (Export). The powered bi-amped loudspeaker system shall be the Peavey PVXp 10 Bluetooth or approved equivalent.